Change a Propane Tank
Propane powered forklifts are frequently utilized in warehouses. The forklift is made with the propane tank mounted at the back of the operator. The tanks, which look a lot like beer kegs, have to be replaced from time to time since they have a limited lifespan. Drivers of forklifts must always use caution when handling propane tanks. Compressed gases are hazardous, especially since the gas is flammable. Always utilize care when removing and replacing propane tank to avoid injury.
1 To change a propane tank, first stop the lift truck while leaving the engine running, and turn the valve on the tank off. Let the forklift run until the engine dies. This process burns the gas off in the transfer hose which connects the tank and the engine. Prior to taking the next steps, wear the proper safety equipment, like for instance insulated gloves made of either leather or neoprene. It is essential for you to protect your skin from touching the compressed gas, that is extremely cold.
2 The hose of the tank has to be disconnected, followed by removing the tank from its holding straps. When you put in a new tank, tighten the nut to reattach the holding straps and to reconnect the hose at the valve of the tank.
3 Leaks can be checked just by applying soapy water to the valve and opening it slightly. If there is a leak, it would cause bubbles to foam from around the valve. If this happens, inspect the valve area and the connection hose at the nut. The connecting nut should be re-tightened if you detect any leaks in the valve area, and then do the leak inspection process once more. Persistent leaks mean that both the nut and connecting hose would need to be replaced. Then again, if replacing the hose and nut still does not stop the leak, the tank must be replaced.
4 Lastly, open the valve all the way to enable the gas to fill the connecting hose. Afterward you could start the forklift and resume operating.